Close The Top Cover - Canon Pro9500 Mark II Series On-Screen Manual

Replacing an Ink Tank
Important
You cannot print if the ink tank is installed in the wrong position. Be sure to install the ink tank in
the correct position according to the label on the Print Head Holder.
You cannot print unless all the ink tanks are installed. Be sure to install all the ink tanks.
6.

Close the Top Cover.

The printer will start mixing the ink automatically.
Wait until the
Power lamp stops flashing and stays lit and the printer has stopped making operating noise. It
takes about 3 minutes or less.
Do not open the Top Cover while the printer is operating (the
Note
If the Alarm lamp still flashes orange after the Top Cover is closed, refer to "Alarm Lamp
Flashes Orange" in "
When you start printing after replacing the ink tank, the printer starts cleaning the Print Head
automatically. Do not perform any other operations until the printer completes the cleaning of
the Print Head. The
If printed ruled lines are misaligned or the print head position is misaligned, adjust the print head
position.
Aligning the Print Head
See
" of the on-screen manual: Advanced Guide .
Troubleshooting
Power lamp flashes blue while cleaning.
.
Power
lamp is flashing blue).
Page 51 of 541 pages
Page top