Laser Unit - Brother DCP-8070D Service Manual

9.35 Laser Unit

(1) Remove the Hook of the Air duct from the frame. Slide the Air duct to the direction of 1b
and remove the Air duct.
(2) Remove the five cup S M3x6 Taptite screws.
(The left back screw has already remove at "8.13 Main Shield Plate ASSY")
(3) Remove the Protective film from the Flat cable.
(4) Pull out the two Flat cables from the Core.
(5) Remove the Laser unit.
Note:
• Be careful not to lose the Protective film attached on the flat cable.
• Do not touch the Laser scanner window directly.
Taptite, cup S M3x6
Assembling Note:
• Before assembling the Laser unit, make sure put on the Core.
Hook
1a
Hook
Air duct
Fig. 5-245
Laser unit
Fig. 5-246
5-201
Laser unit
Hook
1b
Hook
Hook
Polygon motor (Flat cable)
Taptite, cup S M3x6
Core
Protective film
LD harness
(Flat cable)
Confidential