Nexcom PEAK 715-HT Series User Manual page 44

Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC) installed on the
system board and you wish to use it. If you install an add-in FDC or the system has
no floppy drive, select Disabled in this field.
Onboard Serial Ports (1, 2)
Select an address and corresponding interrupt for the first and second serial ports.
The choices: Auto, 3F8/IRQ4, 3E8/IRQ4, 2F8/IRQ3, 2E8/IRQ3, Disabled.
UART Mode Select
This item allows you to select UART mode.
The choices: Normal, IrDA, ASKIR, SCR.
UR2 Duplex Mode
The choices: Half, Full.
Onboard Parallel Port
This item allows you to determine access On-Board parallel port controller with
which I/O address.
The choices: 378/IRQ7, 278/IRQ5, 3BC/IRQ7, Disabled.
Parallel Port Mode
Select an operating mode for the On-Board parallel (printer) port. Select Normal,
Compatible, or SPP unless you are certain your hardware and software both sup-
port one of the other available modes.
The choices: SPP, ECP, EPP, ECP + EPP.
ECP Mode Use DMA
Select a DMA channel for the port.
The choices: 1, 3.
43