Nexcom PEAK 715-HT Series User Manual page 34

Halt On
This setting determines which type of errors will cause the system to halt during
boot. The options are:
All Errors
No Errors
All, But Keyboard
All, But Diskette
All, But Disk/Key
Base/Extended/Total Memory
These items are automatically detected by the system at start up. These
are display-only fields. You cannot make changes to these fields.
After you have made your selections in the Standard CMOS Setup screen, press
<ESC> to go back to the main screen.
Whenever the BIOS detects a non-fatal error, the system
will be stopped and you will be prompted.
The system boot will not be stopped for any error that may
be detected.
The system boot will not stop for a keyboard error; it will
stop for all other errors.
The system boot will not stop for a disk error; it will stop
for all other errors.
The system boot will not stop for a keyboard or disk error; it
will stop for all other errors.
33