Table of Contents
Advertisement
Figure 41 DL-3400 Setup Parameters – Advanced
Note any
changes to the
Advanced tab
settings.
SET GUARDIAN PARAMETERS
Once the parameters for the existing DL-3400 system are logged, connect the Guardian to proper power supply voltage
(10-30 VDC 60 watt maximum at 10 watt RF power), Connect antenna port to 50 ohm termination. Connect DE-9 to DE-
9 data cable (PN 687-4008-408 or equivalent) to Guardian Setup port.
Note: Guardian FPS default communication port is COM1. Change this if necessary.
- Programming parameters are 57,600, N, 1, DTR – None.
- Handshaking should be set to Buffered with no HS.
With the Guardian connected to a proper power source, antenna terminated, and programming cable connected to the
Setup port of the Guardian, click Config (at the upper left corner of the programming window) to access the Guardian
Configuration window.
Figure 42 Config button
The Guardian FPS will read and display the current configuration of the Guardian that is connected to the computer.
See the following figure. Selecting Loader mode will change the configuration screen to allow analog radio settings.
Guardian™ Serial Modem or Analog Radio for Licensed Spectrum PN 001-5006-000 Rev. 3
Factory default
setting for TX
power output is
5 watts.
| Page 64
Advertisement
Table of Contents
