Table of Contents
Advertisement
If the message was not displayed as typed, then a problem may exist in the system. Check all parameters and
connections in the system. The signal level should also be checked again. The Guardian's Link Test utility can be used to
verify a communication path.
Hex Terminal
Under the Utilities menu choose the Hex Terminal. From the Hex Terminal window, choose the Primary selection.
The previous procedure can also be used with the Hex Terminal utility. When the Hex Terminal is used, the information
is entered as hex code. Figure 37 shows how the information will look when it is typed in and sent in hex. In the Hex
Terminal mode, the program will not transmit ASCII information. It will only allow valid hex characters.
Figure 37 End-to-End Test using Hex Terminal
| Page 56
Guardian™ Serial Modem or Analog Radio for Licensed Spectrum PN 001-5006-000 Rev. 3
Advertisement
Table of Contents
