Table of Contents
Advertisement
Rx Frequency
Displays the receive frequency for the channel pair.
Tx Frequency
Displays the transmit frequency for the channel pair.
Power Output
Displays the transmit power value for the channel pair. The default value is 5.0 Watts. This value should not be
changed from the default value unless a lower power is required to meet regulatory requirements.
Bandwidth
This field specifies whether the unit is half- or full-channel (12.5 or 25 kHz).
RF Baud Rate
This field selects the Network (over-the-air) baud rate.
• When half-channel bandwidth (12.5 kHz) is selected – 4800 or 9600 bps
• When full-channel bandwidth (25 kHz) is selected – 4800, 9600, or 19200 bps
Data Bits
Number of bits making up the data word for the RF Link. Select 7 or 8. The Default is 8.
Parity
Select Even, Odd, Mark, Space, or None to specify the sum of bits for the RF Link. The Default is None.
Stop Bits
Select 1 or 2 to specify which marks the end of the serial port data byte for the RF Link. The Default is 1.
Data Type
Select Enhanced Only or Compatible. The Default is Enhanced Only.
Network Type
Select network type for devices on the network, T-96S/DL-3276, Crystal, or T-96SR/TSLM/Guardian.
The Default is T-96SR/TSLM/Guardian.
5.6.3 COM PORT
Figure 21 COM Port Panel
Port Baud Rate
This field selects the Guardian COM Port baud rate.
Guardian™ Serial Modem or Analog Radio for Licensed Spectrum PN 001-5006-000 Rev. 3
| Page 32
Advertisement
Table of Contents
