Table of Contents
Advertisement
Save
The Save button allows the user to save the current Diagnostics IDs, Alarms and Filters to the current file.
Save As
The Save As button allows the user to save the current Diagnostics IDs, Alarms and Filters to a name different than the
current file.
5.14 OFFLINE LINK TEST
The Offline Link Test window is accessed from the Utilities menu.
The Offline Link Test is used to test the link between two units: the local unit interfaced to the computer and a remote
unit. Blocks of data are transmitted to the remote unit and the remote unit decodes and returns them. The transmitted
and received blocks of data are compared and ratios of the results are calculated.
Note: An Offline Link Test requires suspension of user network operation.
Figure 30 Offline Link Test Window
Remote Select
Local ID: The Long ID of the unit connected to the computer. The Short ID is displayed.
Remote ID: Allows selection of the unit (by choosing its Remote ID) from which the Link Test information is gathered.
Remote IDs are set up in the Diagnostics IDs, Alarms and Filters window. The Short ID is displayed. An Offline Link Test
returns the following statistics:
Blocks Tx'ed to Remote
Displays the number of data blocks transmitted to the remote unit.
Blocks Rx'ed from Remote
Displays the number of data blocks received from the remote unit.
Link Quality
Displays the ratio of data blocks received to data blocks transmitted (in %).
| Page 44
Guardian™ Serial Modem or Analog Radio for Licensed Spectrum PN 001-5006-000 Rev. 3
Advertisement
Table of Contents
