Hitachi WJ200 Series Quick Reference Manual page 74

CALL NOW 800-985-6929
09
11
12
13
14
15
16
18
19
Option
Code
20
21
22
23
24
27
CALL NOW 800-985-6929
http://www.automatedpt.com
2-stage Acceleration
2CH
and Deceleration
FRS Free-run Stop
EXT External Trip
Unattended Start
USP
Protection
Commercial
CS
source switchover
SFT Software Lock
Analog Input
AT
Voltage/Current Select
RS Reset Inverter
PTC thermistor Thermal
PTC Protection
(C005 only)
Input Function Summary Table
Terminal
Function Name
Symbol
STA Start
(3-wire interface)
STP Stop
(3-wire interface)
F/R FWD, REV
(3-wire interface)
PID PID Disable
PIDC PID Reset
UP Remote Control UP
Function (motorized
speed pot.)
http://www.automatedpt.com
Frequency output uses 2nd-stage acceleration
ON
and deceleration values
Frequency output uses standard acceleration
OFF
and deceleration values
Causes output to turn OFF, allowing motor to free
ON
run (coast) to stop
Output operates
OFF
deceleration stop motor
When assigned input transitions OFF to ON,
ON
inverter latches trip event and displays
No trip event for ON to OFF, any recorded trip
OFF
events remain in history until reset
On powerup, the inverter will not resume a Run
ON
command (mostly used in the US)
On powerup, the inverter will resume a Run
OFF
command that was active before power loss
power ON Motor can be driven by commercial power
OFF Motor is driven via the inverter
The keypad and remote programming devices
ON
are prevented from changing parameters
OFF The parameters may be edited and stored
ON
Refer to "Analog Input Settings" on page 3-13.
OFF
The trip condition is reset, the motor output is
ON
turned OFF, and powerup reset is asserted
OFF Normal power-ON operation
When a thermistor is connected to terminal [5]
and [L], the inverter checks for over-temperature
ANLG
and will cause trip event and turn OFF output to
motor
A disconnect of the thermistor causes a trip
OPEN
event, and the inverter turns OFF the motor
ON Starts the motor rotation
OFF No change to present motor status
ON Stops the motor rotation
OFF No change to present motor status
ON Selects the direction of motor rotation: ON = FWD.
While the motor is rotating, a change of F/R will start
a deceleration, followed by a change in direction
OFF Selects the direction of motor rotation: OFF = REV.
While the motor is rotating, a change of F/R will start
a deceleration, followed by a change in direction
ON Temporarily disables PID loop control. Inverter
output turns OFF as long as PID Enable is active
(A071=01)
OFF Has no effect on PID loop operation, which operates
normally if PID Enable is active (A071=01)
ON Resets the PID loop controller. The main
consequence is that the integrator sum is forced to
zero
OFF No effect on PID controller
ON Accelerates (increases output frequency) motor from
current frequency
OFF Output to motor operates normally
72
Email: charles@automatedpt.com
normally, so controlled
E 12
Description
Email: charles@automatedpt.com