Hitachi WJ200 Series Quick Reference Manual page 17

CALL NOW 800-985-6929
Keys, Modes, and Parameters
The purpose of the keypad is to provide a way to
change modes and parameters. The term function
applies to both monitoring modes and parameters.
These are all accessible through function codes that are
primary 4-character codes. The various functions are
separated into related groups identifiable by the
left-most character, as the table shows.
You can see from the following page how to monitor and/or program the parameters.
Keypad Navigation Map
The WJ200 Series inverter drives have many programmable functions and parameters.
Chapter 3 will cover these in detail, but you need to access just a few items to perform the
powerup test. The menu structure makes use of function codes and parameter codes to
allow programming and monitoring with only a 4-digit display and keys and LEDs. So, it is
important to become familiar with the basic navigation map of parameters and functions in
the diagram below. You may later use this map as a reference.
CALL NOW 800-985-6929
http://www.automatedpt.com
Function
Type (Category) of Function
Group
"D" Monitoring functions
"F" Main profile parameters
"A" Standard functions
"B" Fine tuning functions
"C" Intelligent terminal functions
"H" Motor constant related functions
"P" Pulse train input, torque, EzSQ, and
communication related functions
"U" User selected parameters
"E" Error codes
http://www.automatedpt.com
8888
RUN
ESC
Mode to Access
Monitor
Program
Program
Program
Program
Program
Program
Program
−
15
Email: charles@automatedpt.com
RUN PWR
Hz ALM
A
PRG
STOP/
1
RESET
2 SET
PRG LED
Indicator
−
Email: charles@automatedpt.com