Hitachi WJ200 Series Quick Reference Manual page 78

CALL NOW 800-985-6929
Option
Code
22
23
24
25
26
27
28
31
32
33
34
35
39
40
CALL NOW 800-985-6929
http://www.automatedpt.com
Output Function Summary Table
Terminal
Function Name
Symbol
DSE Speed Deviation
Excessive
POK Positioning Completion
FA4 Frequency Arrival Type
4–Over frequency
FA5 Frequency Arrival Type
5–Set frequency
OL2 Overload Advance
Notice Signal 2
ODc Analog Voltage Input
Disconnect Detection
OIDc Analog Current input
Disconnect Detection
FBV PID Second Stage
Output
NDc Network Disconnect
Detection
LOG1 Logic Output Function 1
LOG2 Logic Output Function 2
LOG3 Logic Output Function 3
WAC Capacitor Life Warning
Signal
WAF Cooling Fan Warning
Signal
http://www.automatedpt.com
Description
OFF Output frequency is higher than the threshold
specified in C063
ON Deviation of speed command and actual speed
exceeds the specified value P027.
OFF Deviation of speed command and actual speed
does not exceed the specified value P027.
ON Positioning is completed
OFF Positioning is not completed
ON When output to motor is at or above the set freq.,
even if in accel (C045) or decel (C046) ramps
OFF When output to motor is OFF, or at a level below
the set frequency
ON When output to motor is at the set frequency,
during accel (C045) and decel (C046).
OFF When output to motor is OFF, or is not at a level of
the set frequency
ON When output current is more than the set
threshold (C111) for the overload signal
OFF When output current is less than the set threshold
for the deviation signal
ON
When the [O] input value < B070 setting (signal
loss detected)
OFF When no signal loss is detected
ON
When the [OI] input value < B071 setting (signal
loss detected)
OFF When no signal loss is detected
ON Transitions to ON when the inverter is in RUN
Mode and the PID Process Variable (PV) is less
than the Feedback Low Limit (C053)
OFF Transitions to OFF when the PID Process Variable
(PV) exceeds the PID High Limit (C052), and
transitions to OFF when the inverter goes from
Run Mode to Stop Mode
ON When the communications watchdog timer (period
specified by C077) has time out
OFF When the communications watchdog timer is
satisfied by regular communications activity
ON
When the Boolean operation specified by C143
has a logical "1" result
OFF
When the Boolean operation specified by C143
has a logical "0" result
ON
When the Boolean operation specified by C146
has a logical "1" result
OFF
When the Boolean operation specified by C146
has a logical "0" result
ON
When the Boolean operation specified by C149
has a logical "1" result
OFF
When the Boolean operation specified by C149
has a logical "0" result
ON Lifetime of internal capacitor has expired.
OFF Lifetime of internal capacitor has not expired.
ON Lifetime of cooling fan has expired.
76
Email: charles@automatedpt.com
Email: charles@automatedpt.com