Installing Or Removing A Power Supply - IBM eServer 232 xSeries User Reference Manual

7. Set the fan sink into place.
8. Press down and latch the spring retention clip on the back of the fan sink (the side
9. Press down and latch the spring retention clip on the front of the fan sink (the side
10. Plug the fan sink into the fan sink connector on the system board (J46). Make
11. If you have other options to install or remove, do so now; otherwise, go to

Installing or removing a power supply

u p p l y e m o v i n g a p o w e r s I n s t a l l i n g o r r Your server comes with one 385-watt power supply or two 250-watt power supplies.
The 385-watt power-supply configuration can be upgraded with an optional backplane
that will enable you to install up to three power supplies, which enables redundancy
and will make the power supplies hot-swappable. Each power supply has two status
66
IBM xSeries 232: User's Reference
Microprocessor
release lever
Make sure the fan sink guide fits between the processor and the processor
socket.
Fan sink guide
facing the back of the server).
facing the front of the server).
sure the cable is not in a position to interfere with the fan sink operation.
"Installing the bezel and front door" on page 74.
Fan sink
(Remove thermal tape
liner on installation)
Ensure correct alignment
of fan sink, mounting clip,
and mounting socket
Spring retention clip