Running Method By Autotuning Data - Hitachi J300 Series Instruction Manual

Running method by autotuning data

When running the inverter using the autotuning data:
1. A-0 : The control method is set at SLV (sensorless vector control).
2. A-98
Make the above two settings.
NOTE: When no torque is outputted during the sensorless vector run after the above settings are
made, make the following settings. Increase the set value of R1 of each remote operator
(motor constant) before starting running.
[Setting method]
(1) Digital operator
A 0
A 0
A 98
A 98
(2) Remote operator
F-04
FUNC
Initial display
CONTROL
× 4
CONTROL
STR
Initial display
AUX
× 2
× 2
AUX
STR
MON
FS050.00
CTi Automation - Phone: 800.894.0412 - Fax: 208.368.0415 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
: The motor data is set on the autotuning side by the software switch.
FUNC
0
FUNC
4
FUNC
00
FUNC
02
CONTROL
VC
SLV
DATA NOR
DATA AUT
000.00Hz
1. Select 4 (sensorless vector control) by
the control method.
0: Constant torque characteristic
1: Reduced torque characteristic (1.5 power)
2: Reduced torque characteristic (1.7 power)
3: Reduced torque characteristic (2.0 power)
× 4
4: Sensorless vector control
2. Set the motor constant data to the data which is
A measured by the autotuning function
9 8
using the software switch.
(Refer to the [A98] software switch of the opera-
× 2
tion manual.)
(When executing the second setting, change the
switch.)
By the above two settings, running by the autotuning
data is available.
1. Select [SLV] (sensorless vector control) by the
F-04 control method.
VC: Constant torque characteristic
VP1: Reduced torque characteristic (1.5 power)
VP2: Reduced torque characteristic (1.7 power)
VP3: Reduced torque characteristic (2.0 power)
SLV: Sensorless vector control
2. Set the [AUT] autotuning data by motor data
selection of the F-05 motor constant.
By the above two settings, running by the autotuning
data is available.
A-5