Precautions - Hitachi J300 Series Instruction Manual

WARNING: This equipment should be installed, adjusted and serviced by qualified electrical
maintenance personal familiar with the construction and operation of the equipment
and the hazards involved. Failure to observe this precaution could result in bodily injury.
WARNING : The user is responsible for ensuring that all driven machinery, drive train
mechanism not supplied by Hitachi, Ltd., and process line material are capable of safe operation
at an applied frequency of 150% of the maximum selected frequency range to the AC motor.
Failure to do so can result in destruction of equipment and injury to personnel should a single
point failure occur.
WARNING : For protection, install a leak breaker type with a high frequency circuit capable
of large currents to avoid an unnecessary operation. The ground fault protection circuit is not
designed to protect personal injury.
WARNING :
POWER BEFORE WORKING ON THIS CONTROL.
AVERTISSEMENT : RISQUE DE CHOC ELECTRIQUE COUPER L'ALIMENTATION
AVANT LE DEPANNAGE DE CETTE COMMANDE.
WARNING : SEPARATE MOTOR OVERCURRENT, OVERLOAD AND OVER-
HEATING PROTECTION IS REQUIRED TO BE PROVIDED IN ACCORDANCE
WITH THE SAFETY CODES REQUIRED BY JURISDICTIONAL AUTHORITIES.
AVERTISSEMENT :
DISTINCTE CONTRE LES SURINTENSITES, LA SURCHARGE ET LA
SURCHAUFFE,CONFORMEMENT AU CODE CANADIEN DE L'ELECTRICITE<
PREMIERE PARTIE.
CAUTION: These instructions should be read and clearly understood before working on J300
series equipment.
CAUTION: Proper grounds, disconnecting devices and other safety devices and their location
are the responsibility of the user and are not provided by Hitachi, Ltd.
CAUTION: Be sure to connect a motor thermal switch or overload device to the J300 series
controller to assure that the inverter will shut down in the event of an overload or an overheated
motor.
CAUTION: DANGEROUS VOLTAGE EXISTS UNTIL CHARGE LIGHT IS OFF.
ATTENTION: PRESENCE DE TENSIONS DANGEREUSES TANT QUE LE VOYANT
N'EST PAS ETEINT.
CAUTION: Rotating shafts and above ground electrical potentials can be hazardous. There-
fore, it is strongly recommended that all electrical work conform to the National Electrical Codes
and local regulations. Installation, alignment and maintenance should be performed only by
qualified personnel. Factory recommended test procedures, included in the instruction manual,
should be followed. Always disconnect electrical power before working on the unit.
CTi Automation - Phone: 800.894.0412 - Fax: 208.368.0415 - Web: www.ctiautomation.net - Email: info@ctiautomation.net

PRECAUTIONS

HAZARD OF ELECTRICAL SHOCK. DISCONNECT INCOMING
LE MOTEUR DOIT ETRE MUNI D'UNE PROTECTION
- ii -