Hitachi J300 Series Instruction Manual page 53

Monitor
mode
contents
Adjust the analog meter connected to the frequency monitor
terminal. (Initial setting of the [FM] terminal: Analog frequency monitor)
When operation starts, t/T output between FM and CM1 terminals is
proportional to the output data. Adjust the meter so that it indicates
the maximum point when the output is at the maximum.
Analog
meter
adjustment
Motor
receiving
voltage
setting
Extension
function
setting
CTi Automation - Phone: 800.894.0412 - Fax: 208.368.0415 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
1
FUNC
Initial value
1
NOTE 1: This function is valid only when the analog monitor is used.
(Freqency monitor, current monitor, torque monitor)
NOTE 2: The adjusted value when the input terminal STN (initialization) is used is
the initial value.
Set the motor receiving voltage. When the
of the motor receiving voltage is displayed.
200 V class
FUNC
FUNC
400 V class
Select the item of each extension function. After setting, the display is returned to the code
display.
After data is changed, be sure to press the
FUNC
FUNC
Contents and display
2
FUNC
When adjusting the analog meter furthermore, repeat the same operation.
2
Frequency monitor:
Current monitor:
Torque monitor:
FUNC
FUNC
Code selection
FUNC
2
1
When the
blinking and the data is stored.
7-13
t
T
t (variation)
Output =
T
Maximum level of analog meter
(A63 maximum frequency setting)
(200% of inverter rated current)
(200% of rated torque)
key is pressed once, the current set value
1
Initial value
2
1
Initial value
2
key to store it.
Code selection
2
1
When the data is changed,
the display blinks.
(Set value storage wait state)
FUNC
key is pressed, the display stops
Sink type wiring
Refer to page 5-3
FM
CM1
PLC
P24