Hitachi J300 Series Instruction Manual page 101

(Function mode 1)
Display
Function
sequence
No.
19 F-26
Frequency lower limiter
limiter
20 F-27
Jump
frequency setting (1)
21 F-28
22 F-29
23 F-30
24 F-31
External
analog
frequency External
command frequency
CTi Automation - Phone: 800.894.0412 - Fax: 208.368.0415 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
(Function mode 2)
Function Initialization display
name contents
Frequency LIMIT L 0000.0 Hz
setting
Frequency LIMIT H 0000.0 Hz
upper
limiter
setting
Jump JUMP F1 0000.0 Hz
frequency
Jump JUMP F2 0000.0 Hz
frequency
setting (2)
Jump JUMP F3 0000.0 Hz
frequency
setting (3)
Jump JUMP W
frequency
width setting
STOP key STOP-SW
validity
selection
during
terminal
running
Running F/R SW
direction
selection
Reverse run F/R PREV
prevention
selection
Reduced F/R RVS
voltage
soft start
setting
Maximum F-MAX-L
frequency
selection
Analog input IN ANA
voltage
selection
IN EXS 0000.0 Hz
start setting
External IN EXE 0000.0 Hz
frequency
end setting
External IN EX%S
frequency
start setting
rate
External fre- IN EX%E
quency end
setting rate
External IN LEVEL
command
start point
selection
Setting, change
Initialization
0 Hz
0 Hz
0 Hz
0 Hz
0 Hz
0.5 Hz 0.5 Hz
ON ON ON: STOP key
OFF: STOP key
FRE FRE
OFF OFF
6 6
120 Hz 120 Hz
10 V 10 V
0 Hz 0 to 120.0 (400)
0 Hz 0 to 120.0 (400)
000% 0%
100% 100%
0 Hz 0 Hz
12-10
Setting contents
contents
0 to 120.0 The lower limit of the frequency
(400) Hz to be set is set. When the lower
limit is 0, the setting is invalid.
0 to 120.0 The upper limit of the frequency
(400) Hz to be set is set. When the upper
limit is 0, the setting is invalid.
0 to 400 Hz • The section where frequencies
are to be jumped is set.
• Up to three locations can be
set.
• When the number of locations
is 0, the setting is invalid.
0 to 400 Hz
0 to 400 Hz
0 to 9.9 Hz • The frequency width where
frequencies are jumped is set.
Whether or not to make the
valid STOP key valid during terminal
running is selected. In the
invalid Remote mode, the STOP key is
always valid.
FWD/REV/ FWD: Only forward run
FRE REV: Only reverse run
FRE: Both forward run and
reverse run valid
ON/OFF Reverse run prevention
ON:
OFF:
0 to 6
120/400 Hz Maximum frequency switching:
120: 120 Hz 400: 400 Hz
10/5 Input voltage maximum level
10: Max. 10 V 5: Max. 5 V
• Frequency at which the
external input starts
• Frequency at which the
external input is maximized
0 to 100 • Input start level
0 to 100 • Input maximum level
0 Hz/ExS EXS: Start at EX%S setting
rate or less