Hitachi J300 Series Instruction Manual page 97

(Function mode 1)
Display
Function
sequence
No.
6 F-05
Motor
constant
7 F-06
Accelera- tion time
tion time
8 F-07
Decelera- tion time
tion time
CTi Automation - Phone: 800.894.0412 - Fax: 208.368.0415 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
(Function mode 2)
Function Initialization display
name contents
Motor AUX M 123.60 mH
M setting
constant
Motor AUX J 0.44 kgm
J setting
constant
Motor AUX Kp
constant
Kp setting
Motor AUX Ti
constant
Ti setting
Motor AUX KPP
constant
KPP setting
Accelera- ACC 1
setting
2-stage ACC 2
acceleration
time setting
Curve ACC LINE
pattern
selection
for
acceleration
Accelera- ACC GAIN
tion and
deceleration
curve
constant
selection
Decelera- DEC 1
setting
2-stage DEC 2
deceleration
time setting
Curve DEC LINE
pattern
selection
for
deceleration
Accelera- DEC GAIN
tion and
deceleration
curve
constant
selection
Initialization
Rated capacity
of each inverter
2
Rated capacity
of each inverter
002.00 2.0
00100 ms 100 ms
001.00 1.0
0030.00 s 30.00 s
0015.00 s 15.00 s
L L
02 2 (common to
acceleration
and
deceleration)
0030.00 s 30.00 s
0015.00 s 15.00 s
L L
02 2 (common to
acceleration
and decelera-
tion)
12-6
Setting, change
Setting contents
contents
0 to 655.35 • Primary self inductance per
phase.
0 to 655.35 • Motor and machine inertia
0 to 100.00 • Smaller: High response
• Larger: Low response
0 to 10000 • Set this item after the
feedback option PCB is
installed.
0 to 100.00 • Set this item after the
feedback option PCB is
installed.
0.01 to 3000 • When the fuzzy most
suitable acceleration and
deceleration (F-10) are set,
the time displayed here is
invalid, though it can be
set.
0.01 to 3000 • The acceleration time can
be used when the input
terminal CH1 is shorted.
• For input terminal
selection, refer to F-34
input terminal.
L (Linear), • The curve pattern is set for
S (S curve), acceleration and
U (U curve), deceleration respectively.
RU (reverse
U curve)
1 to 10 • When the constant is set
for one of acceleration and
deceleration, it is common
to both acceleration and
deceleration.
• See appendix 4.
0.01 to 3000S • When the fuzzy most
suitable acceleration and
deceleration (F-10) are set,
the time displayed here is
invalid, though it can be
set.
0.01 to 3000S • The deceleration time can
be used when the input
terminal CH1 is shorted.
• For input terminal
selection, refer to F-34
input terminal.
L (Linear), • The curve pattern is set for
S (S curve), acceleration and decelera-
U (U curve), tion respectively.
RU (reverse
U curve)
1 to 10 • When the constant is set
for one of acceleration and
deceleration, it is common
to both acceleration and
deceleration.
• See appendix 4.