Note: If the bridged appearance rings on your phone, this step is not necessary; you will
automatically be connected to call when you answer.
2. The speakerphone will activate when the call appearance button is pressed or you can
pick up the handset.
To search the directory for a name:
1. Press the Directory button (if administered).
2. Key in the selected name with dial pad keys: last name, comma (use * ), first name or
initial.
3. Press the Next button for each successive directory name you wish to see. (The Next
button must be administered by your system manager.)
4. To search for a new name, press the Directory button and go through the above sequence
again.
5. When you are ready to exit the directory, press the
To place a call to the name shown on the display:
1. Pick up the handset.
2. While the name is shown, press the Call Disp button (if administered) or, if you do not
have a Call Disp button on your set, press the
number using the dial pad.
Note: You can also leave your handset on-hook. The speakerphone will turn on
automatically when you press Call Disp if this system feature is enabled.
The dial intercom feature must be administered by MSU Telecom Systems.
To make a call to a member of your intercom group:
1. Press Intercom button.
2. Dial the group member's 1- or 2-digit code.
A special intercom ring is sent.
o
Directory
Dial Intercom
Label Action
30
Exit button.
Exit button and then dial the