Auto Pan - Brickcom OSD-200 20xp User Manual

To stop running a Cruise Path, simply move the cursor to the live view
pane and move the camera in any direction.

9.3 Auto Pan

The Auto Pan Programming can be found under this path: PTZ> Auto Pan.
The IP Camera supports four Auto Pan Paths. Please refer to the instructions
below to set an Auto Pan Path.
A. Auto Pan Setting
To setup an Auto Pan Path, please select a path number from the
drop-down list first. Then move the cursor to the live view pane, and
move the camera to a desired view as the Start Point of an Auto Pan
Path. Click on the <Set> button of the <Start Point> and the current
view will be automatically saved as the start point of the Auto Pan Path.
NOTE- The zoom ratio of an Auto Pan's Start Point will persist
throughout the whole path.
Enter the speed ratio into the Speed field; the speed ratio ranges from 0
(low) to 3 (fast). Then choose to run the Auto Pan Path in right/left
direction from the Direction drop-down list.
Move the camera to another desired position as the end point of the
Auto Pan Path. Click on the <Set> button of the <End Point> to save
the setting.
B. Auto Pan Run
Select the specified Auto Pan Path from the drop-down list, click on the
<Run> button, and then the camera will start moving horizontally as
recorded.
To view the camera panning in full screen mode, please move the
cursor onto the live view pane, right-click and left-click to select "full
screen". Then users can view the camera navigation in full screen.
66