Schedule - Brickcom OSD-200 20xp User Manual

2 megapixel speed dome network camera

Table of Contents

B. Terminating Micro SD / SDHC Card Recording

Select <Disable> to terminate the recording function.

7.13 Schedule

The Schedule setting can be found under this path: System> Schedule.

This function allows the users to setup schedules for features including:

<Alarm Switch>, <Motion Detection> and <Network Failure Detection>. The

function supports up to 10 sets of time frames in the time frame list.

A. Setting Schedules

To set a schedule, please select a time frame from the time frame list

first. Then check the boxes from below to choose the specific

weekdays. At last, type in the start time (hour:minute) and the duration

time (hour:minute) for activation of the schedule triggered features. The

setting range for the duration time is from 00:00 to 168:59. Click

<Delete> to delete a chosen time frame. Please click on <Save> to

save the setup.

NOTE- Users MUST select <By schedule> under each feature

setting page to enable the schedule function.

Table of Contents

Do you have a question about the OSD-200 20xp and is the answer not in the manual?