Advertisement
Quick Links
Advertisement
Related Manuals for Brickcom OB-E200Nf-S
Summary of Contents for Brickcom OB-E200Nf-S
- Page 1 Megapixel Network Camera Easy Installation Guide OB-E200Nf-S...
-
Page 2: Safety Instruction
I. Preface Thank you for purchasing our product. If there is any question, please do not hesitate to contact us. These instructions are intended to ensure that the user can use the product correctly to avoid danger or property loss. Please read this Guide carefully before using the product, and keep it properly for future reference. - Page 3 3. Daily Maintenance Do not touch the heat component of the device directly to avoid empyrosis. When the lens is contaminated by dust or grease, use cotton cloth or lens clean cloth to wipe it off. When it is hard to clean, dip some lens cleanser and wipe gently and rotate outward from the middle until it is clean. Never apply any organic solvent with ethanol or benzene to clean the lens and housing.
-
Page 4: Appearance And Interface
III. Appearance and Interface Dimensions: Unit: mm Components: Component Name Mount Base Side Cable Hole Sun Shade Lens Locknut... - Page 5 Buttcock line: Table 1 Wiring Interface Interface Name Interface Function Power Supply Connect to power supply of DC12V Network Connect to network access devices like a switch IV. DC12V Wire Diameter VS. Transmission Distance The recommended max transmission distance when the wire diameter is certain and the voltage loss rate is less than 10% Requirements of max length and power for power cords of different diameters (for your reference).
-
Page 6: Installation
V. Installation The camera supports wall bracket mount and pendent mount. You can perform ceiling or wall mount when the wall or ceiling are thick and solid enough for fixing self-tapping screws and meanwhile strong enough for bearing the device. Camera weight: 460g (net) Wall bracket mount Pendent mount... - Page 7 Wall Bracket Mount: The installation steps of wall bracket mount and pendent mount are the same. This part will take wall bracket mount as an example to introduce the installation steps. Install TF card (optional). Some models support TF card. Insert a TF card into the slot as shown in the following picture.
- Page 8 Route cables. When routing cables from the top, route cables through the mounting surface. When routing cables from the profile side, route cables through the U-shaped groove at the side of the bracket base. Side wiring Top wiring...
- Page 9 Fix device base onto the wall. Align the 3 screw holes on the device base to those 3 expansion screw bolts on the mounting surface. Screw up the 3 tapping screws through the base and tighten them into the 3 expansion screw bolts.
- Page 10 VI.Login to Client 1. Minimum configurations and system requirements: Processor: 3.3 GHz CORE®i3 series or other equivalent processors Ÿ RAM Memory: 4GB or above Ÿ Operating System: Windows XP or newer version Ÿ Browser: IE7.0 and newer version, Firefox, Google Chrome (41 and lower) Ÿ...
- Page 11 3. Modify device IP address Click "Modify Params" and set the network parameters. When configuring a static IP for the camera, please check “Custom device address (Close DHCP)” and fill the Ethernet parameter. During the modification, the user name (admin) and the password set before activation should be entered. After configuration, the camera will reboot automatically and this takes 60s.
- Page 12 2) After login, download and install the plug-in. Close browser during installation. 3) Re-login to the web client and view live video directly. [Note]: Interface of different models may differ. Please subject it to the actual product. Please refer to the Help file for detailed explanation.
- Page 13 V1 20190716...