Your Filter - Removal & Replacement; "Telewir" Skim Filter; Whitewater Skim Filter - Sunrise spas Spas Owner's Manual

YOUR FILTER – REMOVAL & REPLACEMENT
Our various spa models use different filter systems depending on the spa design. Identify which filter
system is in your spa and check () it off for future reference.
"TELEWEIR" SKIM FILTER
Single cartridge mounted vertically 50 sq ft, 14 ½" (36.8cm) high (part #PWW50L)
Also available: Dual Core Cartridge (part #PDC570-AFS)
HILO MODEL ONLY: Single cartridge mounted vertically 35 sq ft, 5"( 12.7cm) diameter x 8 ½"
(21.6 cm) high (part #PWW35L)

WHITEWATER SKIM FILTER

Dual cartridges mounted vertically 50 sq ft each, 8" (20cm) high (part #PPG-50P4)
Sunrise Spas 2014 Owner's Manual
1. Shut off your spa at the Ground Fault Circuit
Interrupter (GFCI) or Residual Current
Detector (RCD).
2. Lift the floating weir and filter sleeve straight
up above the filter body to remove.
3. Use the cartridge handle to thread the
cartridge out of the filter body.
4. Examine, clean, rotate or replace the
cartridge as necessary.
5. Hold the filter sleeve and twist weir top to
remove weir and allow basket debris to be
dumped out.
6. Reverse the procedure to install new or
cleaned cartridges.
1) Shut off your spa at the Ground Fault Circuit
Interrupter (GFCI) or Residual Current
Detector (RCD).
2) Remove the decorative top cover.
3) Remove each cartridge by simply grasping
the handle and turning it until it threads out
of the cartridge mount.
4) Reverse the procedure to install new or
cleaned cartridges.
7
DOC: SRS-M-B