Sunrise spas Spas Owner's Manual page 115

System-Related Messages
Program memory failure* – M022**
At Power-Up, the system has failed the Program Checksum Test. This indicates a problem with the firmware (operation
program) and requires a service call.
The settings have been reset (Persistent Memory Error)* – M021**
Contact your dealer or service organization if this message appears on more than one power-up.
The clock has failed* – M020**
Contact your dealer or service organization.
Configuration error (Spa will not Start Up)
Contact your dealer or service organization.
The GFCI test failed (System Could Not Test the GFCI) – M036**
(North America Only) May indicate an unsafe installation. Contact your dealer or service organization.
A pump may be stuck on – M034**
Water may be overheated. POWER DOWN THE SPA. DO NOT ENTER THE WATER. Contact your dealer or service organization.
Hot fault – M035**
A Pump Appears to have been Stuck ON when spa was last powered
POWER DOWN THE SPA. DO NOT ENTER THE WATER. Contact your dealer or service organization.
* Some messages can be reset from the panel. Messages that can
be reset will appear with a "right arrow" at the end of the message.
Press the message text to reset the message.
Clean the filter
**M0XX is a Message Code. Codes like this will be seen in the Fault Log
Manufactured under one or more of these patents. U.S. Patents: 5332944, 5361215, 5550753, 5559720, 5,883,459, 6253227, 6282370, 6590188, 6976052, 6965815, 7030343, 7,417,834 b2,
Canadian Patent: 2342614, Australian patent: 2373248 other patents both foreign and domestic applied for and pending. All material copyright of Balboa Water Group.
42256_A 01-09-14