Electrical Connection - General Information; Supply Cable Entry Into Spa Equipment Area; How To Pass The Cable Through The Spa Enclosure; 115 Volt Cord Connection - Sunrise spas Spas Owner's Manual

ELECTRICAL CONNECTION – GENERAL
INFORMATION

SUPPLY CABLE ENTRY INTO SPA EQUIPMENT AREA

 In all cases the best side for entry of the supply cable is the side to your left when you are standing
at the equipment panel.
 Right side entry is possible; however, this may involve additional supply cable, parts and time.

HOW TO PASS THE CABLE THROUGH THE SPA ENCLOSURE

POLYSTEEL FRAME WITH POLYETHYLENE BOTTOM AND POLYSTEEL PANELS
a) You can choose to notch the polysteel panel so you can pass the cable/conduit through and still be
able to remove/replace the panel for servicing. You should consider securing the cable or conduit to
the spa's metal frame where cable/conduit passes through the cabinet.
b) You may also route a cable up under the corner. The curved panel is flexible enough and there is
enough space to run the cable this way. Removing the corner may help you to do this easier.
c) On a concrete pad where you have a conduit or cable coming up within the perimeter of the spa,
you can easily cut an opening in the polyethylene bottom to access the cable or conduit/wires. See
above table for recommended opening location.
You may wish to insulate any opening or cut-out you make in the spa's cabinet panel or corner or bottom
to keep cold air and small animals out.

115 VOLT CORD CONNECTION

This unit has been built, tested and approved with a cord connected 115VAC built in Ground Fault Circuit
Interrupter (GFCI).
The cord must only be plugged into a receptacle that is connected to
a dedicated 15A breaker or fuse.
DO NOT extend the connection by the use of an extension cord. This
will void the warranty and could cause damage to the spa and its'
users.
GFCI Test Procedure:
1. With the GFCI plugged into a grounded 115VAC, 15A outlet
press the yellow TEST button.
2. The spa should shut off and a small light between the TEST
and RESET buttons should be lighted.
3. Press the red RESET button to reset the GFCI and start the spa.
FAMILIARIZE yourself with the test procedure for the GF CI. TEST the GFCI upon every use of the spa.
If the GFCI does not shut the spa off when the TEST button is pressed or does not start up when the
RESET button is pressed DO NOT USE THE SPA. Contact your dealer and/or a qualified electrician
immediately. Take steps to ensure that no person(s) can use the spa while the problem is being reviewed
and corrected.
4
DOC: SRS-M-B
unrise Spas 2014 Owner's Manual
S