Connecting Data Storage; Connecting A Home Network; Inserting The Batteries Of The Rcu; Basic Operation - Mirage smartSTREAM - BOX2IP User Manual

4.5

Connecting Data Storage

 Connect a data storage (USB stick or hard drive with USB connection) at the USB con-
nector to be able to access MPEG, MP3, JPG or other media data files.
4.6

Connecting a Home Network

 In order to connect the receiver to the internet (www) or to a home network, connect the
receiver's ETHERNET socket with a network cable to the appropriate interface of your
home network.

 See section 8.1.1.1 on page 37 to learn how to configure a wired LAN.
4.7

Inserting the Batteries of the RCU

This is the procedure to insert new RCU batteries or to replace empty batteries:
 Open the battery cover at the bottom of the RCU.
 Insert two batteries 1.5 V (Type: AAA). Take care of the right polarity!

5

Basic Operation

This chapter describes the necessary steps to use easily the radio and television programs
broadcasted via satellite.
5.1

Switching on Receiver

1. Switch on all connected devices.
2. Ensure that the correct AV input is selected at the TV set (i.e. that the signals from the
receiver are displayed).
3. Connect the mains plug to the power outlet to switch on the receiver
or
Switch on the receiver by using the power switch (on the rear panel of housing) (I, ON)
5.2

Software Update


Depends on your receiver type.
5
 Replace batteries when the range of the remote control is de-
creasing or when the receiver no longer reacts to all commands.
 When not used for prolonged periods of time, batteries may leak.
Remove batteries from the remote control if it is not used for long
periods of time (> 1.5 years).
 When replacing batteries, always replace all batteries.
Once you have put your receiver into operation, you should first
update the operating software of your receiver!
Basic Operation
5 .
4F
15