Cleaning - Mirage smartSTREAM - BOX2IP User Manual

5. Select the menu item Center Freq to set the frequency corresponding to the IF channel
(see allocation table).
6. Select the menu item Sat Position to set the respective satellite position.
7. Mark the button Save and press OK to save your entries and to return to the first window
Antenna Setup
or
mark the button Cancel and press OK to discard any previous entries in this window and
to return to the first window Antenna Setup without saving.
8. Press the red function key to open the
window Antenna Setup Center Freq.
9. Select the channels using the keys PR+ and PR- (up to 12, depending on your system)
and insert for each the frequency (according to the table above) using the keys
or numeric keys of the remote control.
10. Mark the button Save and press OK to save your entries and to return to the first window
Antenna Setup or mark the button Cancel and press OK to discard any previous entries
in this window and to return to the first window Antenna Setup without saving.
11. Leave the menu by pressing EXIT (settings will be saved). RAPS installation will be con-
tinued automatically.

11 Cleaning

 Always disconnect mains plug from power outlet before cleaning.
 Never clean the receiver using a damp cloth.
WARNING!
 Always ensure that no liquid enters the receiver.
 Do not use solvent-containing cleaning agents like petroleum ether or
CAUTION!
 Clean the housing of the receiver using a dry cloth.
There is the risk of electric shock when cleaning the receiver!
There is the risk of damaging the receiver when cleaning the re-
ceiver!
thinner.
Cleaning
or
53