Format Of The Video Signal At The Scart Output; Digital Audio Out; Simultaneous Playback Of Picture And Sound; Lnb In / Out Loop Through (Loop Standby) - Mirage smartSTREAM - BOX2IP User Manual

Extended Settings and Functions
9.8

Format of the Video Signal at the SCART Output

1. In the window TV system move highlight on Scart Out item and press OK.
2. Press the keys PR+/PR- to select from the list the format of the video signal at the
SCART output and press OK. Possible values are

Due to the internal signal processing it's not anymore possible to select
higher resolutions than 576i even at the HDMI if RGB is selected
9.9

Digital Audio Out

 Select in the menu System Setup the submenu TV System and press OK.
 Select Digital Audio Out to set the format of the digital audio signal by using the keys
and
PCM
– Pulse Code Modulation (default),
DD
– Dolby Digital (multi-channel audio).


9.10 Simultaneous Playback of Picture and Sound

Asynchrony between the image and the sound signals might for example occur in your home
cinema system due to the use of long cables. Your receiver offers the possibility to balance
this by slightly shifting the audio against the video signal.
1. Select in the menu System Setup the submenu Other and press OK.
2. Select AV Sync Value and set a value of shift between
keys und
9.11

LNB IN / OUT Loop Through (Loop Standby)

(only with version II, see section "Receiver", page 7)
Basically, after turning off the receiver it switches to power saving mode ("Deep Standby",
red LED lights up). At the LNB OUT terminal there is no or only a highly attenuated signal. If
you want to use LNB OUT anyway, you can set that in the submenu Other of the System
Setup menu:
 Select Loop Standby to switch on and off the possibility of looping through the satellite
signal, using the buttons
If you select Loop Standby
switching off, but not into the power saving mode. The display shows the
current time.
CAUTION!
50
:
For programs broadcasted in DD format, select DD if you have a con-
nected DD-compatible multi-channel amplifier or a DD-compatible
home cinema system, or if your TV set is capable of processing DD
signals.
(factory default is AV Sync Value
und
YUV RGB
and
-500ms
0 ms
).
(factory default is Loop Standby
On
, the receiver goes into standby mode after
YUV
. Default is .
+500ms
and using the
off
).