Smartlink (Cec); Software Version; Factory Settings; Operation In A Unicable System - Mirage smartSTREAM - BOX2IP User Manual

Hdtv
Hide thumbs Also See for smartSTREAM - BOX2IP:
Table of Contents

Advertisement

9.12

SmartLink (CEC)

If you have a CEC
-compatible TV set, and receiver and TV set are connected via HDMI you
19
18F
can switch on and off (standby mode) both sets with the remote control of your receiver:
1. Select in the menu System the submenu TV System and press OK.
2. Select SmartLink and use the keys
on and off.
9.13

Software Version

The submenu Information of the menu Tools displays the current version number of the
receiver software.
9.14

Factory Settings

If you erroneously saved wrong settings or if you want to pass on the receiver without your
settings, then you can reset the receiver to the factory settings (reset):
To reset the receiver:
1. In the menu Tools, select the submenu Factory Settings.
2. Press the OK key. You will be asked if you want to reset the receiver and delete individu-
al settings.
3. Select Yes or No by using the keys
your receiver, the language selection menu will be displayed.

10 Operation in a Unicable System

10.1

About Unicable

The HDTV receiver allows for changing the receiving mode to the unicable standard. This
makes it possible to connect several independent receivers (up to 12 - depending on the
used system) to only one main line.
For this, an own IF channel and a corresponding frequency should be set for each receiver
via the settings menu.
Allocation of channels and frequencies depends on the used LNBs and/or multi-switches.
The data sheet and the technical documentation of your LNB and/or multi-switch include an
allocation table similar to the following table.
CEC = Consumer Electronics Control = HDMI feature for entertainment units, provides via HDMI various
19
control functions, e. g. "one touch recording" or "system standby". The TV set is the control center and
the TV remote control becomes the remote control of the whole system.
Operation in a Unicable System
und
to switch the SmartLink function
und
, and then press OK. After resetting
51

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents