Transmission Disassembly - Cub Cadet 2000 Series Professional Shop Manual

2000 Series Tractors

Transmission Disassembly

NOTE: The transmission used on 2000 series trac-
tors is driven by a Hydro-Gear BDU-10L-225
pump. The service procedures for that pump
are available in Hydro-Gear service manual
BLN-50327.
1. Drain the oil from the transmission: See Figure 5.31.
1a. Clean the transmission around the drain plug
area.
1b. Remove the drain plug using a 16 mm
wrench. Leave the drain plug out.
2. Remove the transmission assembly by following the
procedures described in the transmission removal
section of this chapter.
3. Disconnect the hydraulic pick up tube to the back of
the BDU-10L using two 11/16 in. wrenches. See
Figure 5.32.
4. Remove the hex cap screw securing the hydraulic
pick-up tube clamp and tube to the right transmis-
sion housing using a 7/16" wrench. See Figure 5.33.
52
Drain plug
Figure 5.31
Flair fitting
Figure 5.32
Clamp
Figure 5.33