Nexcom PEAK650VL2B User Manual page 63

Peak 650 User's Guide
After finishing the above setting, you must be output for the Control Register value to the WDT
Configuration Port. Then WDT will start according to the above setting.
MOV MOV dx, F2h dx, F2h
MOV MOV dx, F2h dx, F2h
OUT OUT dx, al dx, al
OUT OUT dx, al dx, al
You should build in a mechanism in the program to continue to read the WDT Configuration Port for
clearing WDT before the time out.
Apendix
; Setting WDT Configuration Port ; Setting WDT Configuration Port
; Setting WDT Configuration Port ; Setting WDT Configuration Port
; Output the Control Register Value ; Output the Control Register Value
; Output the Control Register Value ; Output the Control Register Value
Rev. A October 2000