Nexcom PEAK650VL2B User Manual page 56

Peak 650 User's Guide
POST (hex)
Enter AWDFLASH.EXE if :
-AWDFLASH is found in Floppy Drive.
- LT+F2  is pressed.
74h Reserved.
Detect & install all IDE devices: HDD, LS120, ZIP, CDROM  .
75h
76h Reserved.
77h Detect Serial ports & Parallel ports.
78h Reserved.
79h Reserved.
7Ah Detect & install Co-processor.
7Bh Reserved.
7Ch Reserved.
7Dh Reserved.
7Eh Reserved.
7Fh 1. Switch back to text mode if full screen logo is supported.
-If errors occur, report errors & wait for keys.
-If no errors occur or
2. Clear EPA or customization logo.
80h Reserved.
81h Reserved.
82h 1. Call chipset power management hook.
2. Recover the text fond used by EPA logo (not for full screen logo).
3. If password is set, ask for password.
83h Save all data in stack back to CMOS.
84h Initialize ISA PnP boot devices.
85h 1. USB final Initialization.
2. NET PC: Build SYSID structure.
3. Switch screen back to text mode.
4. Set up ACPI table at top of memory.
5. Invoke ISA adapter ROMs.
6. Assign IRQs to PCI devices.
7. Initialize APM.
BIOS Setup
Description
1  key is pressed to continue.
E8POST.ASM starts
Rev. A October 2000
4-40