Citizen CL-S400DT User Manual page 42

Chapter 2 Printer Operation
Mode Settings
[Zebra® Emulation]
Top Menu Sub Menu
USB Device Class
[USB Device Clas]
USB VCOM Protocol
[VCOM Protocol]
Machine Model Number
Information
Boot Version
[Machine Info]
ROM Version
ROM Date
ROM CheckSum
FPGA Version
Head Check
Print Counter
Service Counter
Cut Counter
Sensor Monitor
Option Interface
[Option I/F]
Test Mode
Print Pattern
Head Check
Factory Default
Hex Dump
Serial Monitor
Auto Calibration
[Auto Cal]
Sensor Monitor
Global –
configuration
[Global Config]
Note: To restore factory default settings, turn on printer power while pushing the MENU and PAUSE keys simultaneously, then press
the FEED key and the STOP key sequentially.
Default Menu
Printer Printer
VCOM
Auto Auto
DTR
X-ON
– CL-S***
– *.*
– ********
– **/**/**
– ****
– ****.****
– OK
NG
– ****.*** km
– ****.*** km
– *******
– *.* V
– None
IEEE1284
LAN
Current Config Current Config
Global Config
Sample
No Yes
No
No Yes
No
No Yes
No
– –
See Through See Through
Reflect
See Through See Through
Reflect
Config Set 1 Config Set 1
Config Set 2
Config Set 3
42
Remarks
Selects the USB device class.
Selects the protocol (flow control) when
operating USB VCOM.
Displays the model name.
Displays the boot version.
Displays the ROM version.
Displays the date the ROM was prepared.
Displays the check sum of the ROM.
Displays the FPGA version
Displays the results of the head check.
Displays the print counter.
Displays the service counter.
Displays the cut count.
Displays the sensor level.
Displays the presence/absence of the
optional interface.
Executes the test pattern.
Executes head check.
Initializes the set values of the configuration
set to the state when the unit was shipped
from the factory.
Sets the hex dump mode.
Displays the state of the serial interface.
Executes the calibration of the sensor.
Displays the level of the sensor.
Sets the Config Set.