Citizen CL-S400DT User Manual page 40

Chapter 2 Printer Operation
Mode Settings
[Zebra® Emulation]
Top Menu Sub Menu
Standby Mode
Standby Timer
Media Power Up
CI Lock
Emulation Select
Emulation Auto
Detect
[Emulation Auto]
After Print
AutoConfigure
[Auto Config]
Function Select
[Function Sel]
Cutter Action
Peel Wait Delay**
* Only when peeling option is mounted.
**Only when cutter is mounted.
Default Menu
Off On
Off
5 min 1 to 1440 min
Off On
Off
Off On
Off
ZPI2 DM4
DMI
DPP
ZPI2
On On
Off
Full Auto
On On
Off
Tear Off
Tear
Peel On*
Cut On**
Backfeed Backfeed
Through
0.1 sec 0.1 to 2.0 sec
40
Remarks
Choose the Standby Mode
If you switch on the Standby Mode, the
printer will go into power-saving mode after
the elapse of the time set by the Standby
Timer.
You can set the time it takes for the machine
to go into Standby Mode.
Selects whether or not to initiate media
measurement when the power in ON.
Activates/deactivates the CI command.
Selects DataMax®/Zebra® compatibility
DM4: DataMax® 400
DMI: DataMax® IClass
DPP: DataMax® Prodigy Plus®
ZPI2: Zebra® 2844Z
Setting emulation (as above) auto detection.
Automatically configures optional devices.
On . ....AutoConfigure enabled (Regardless
of whether Function Select is set, if a
peeler or cutter is installed, each mode
is set automatically.)
Off ....AutoConfigure disabled (A peeler of
cutter is installed, but to not operate
the peeler or cutter, turn it Off and
the operation is selected by Function
Select.)
Selects the operation when the
AutoConfigure is set to Off. Designates the
paper position based on each option. The
operation of this device is enabled during
selection. At the same time, the parameters
of the f command of Prodigy Plus are
emulated for each optional device.
Sets the cutter action.
With the optional AutoConfigure On,
printing is executed only when the cutter
is installed or only when Cut is selected by
Function Select.
Backfeed is always set after cutting.
Through is set at the rear end of sheets 1 to
n-1 when the number of copies = n, and the
rear end of the final page of single sheet and
the copy is backfeed.
Sets the Peel Wait Delay.
Displays only machines with a peeler
installed.