Citizen CL-S400DT User Manual page 34

Chapter 2 Printer Operation
Mode Settings
[Datamax® Emulation]
Menu Setting Table
Page Setup Menu - allows you to change settings related to the media or print quality.
System Setup Menu - allows you to change settings for the printer hardware and basic control systems.
After Print Menu - changes how the printer reacts after the label has been printed.
Interfaces - changes interface parameters such as baud rate.
Machine Information, Test Mode - allows you to check and/or print test pages and information about the printer.
Global Config menu - allows you to switch between 3 complete 'config sets' contained within the printer.
Menu Setting
Press the MENU key in print possible status to enter MENU Setup Mode. Use the keys on the operation panel
according to the LCD display to setup the printer. The contents that can be setup on the printer are shown
below. And the items that are actually displayed on the LCD are shown in [ ].
 Datamax® Emulation
Top Menu Sub Menu
Page Setup Print Speed*
Print Darkness
Darkness Adjust
[Darkness Adj]
Continuous Media
Length
[Cont Media Len]
Vertical Position
[Vertical Pos]
Horizontal Position
[Horizontal Pos]
Vertical Image Shift
[Vertical Image]
Auto Side Shift
Media Sensor
Small Media
Adjustment
[Small Media Adj]
Small Media Length
[Small Media Len]
Symbol Set
System Setup
Sensor Monitor
Sensor Level
Paper End Level
Error Reporting
[Error Report]
* 2 to 4 IPS with optional peeler.
Default Menu
6 IPS 2 to 6 IPS
10 00 to 30
00 -10 to 10
4.00 inch 0.25 to 32.00 inch
101.6 mm 6.4 to 812.8 mm
0.00 inch -1.00 to 1.00 inch
0.0 mm -25.4 to 25.4 mm
0.00 inch -1.00 to 1.00 inch
0.0 mm -25.4 to 25.4 mm
0.00 inch 0.00 to 32.00 inch
0.0 mm 0.0 to 812.8 mm
00 dots 00 to 15 dots
See Through See Through
Reflect
None
Off On
Off
1.00 inch 0.25 to 1.00 inch
25.4 mm 6.4 to 25.4 mm
PM 50 symbols
– –
1.7 V 0.0 V to 3.3 V
2.80 V 0.01 to 3.00 V
On Printing On Printing
Immediate
34
Remarks
Printing speed setting.
Adjusting print darkness.
Fine adjustment of darkness commands.
Setting media length of continuous media.
Lower level = during mm mode.
Adjusting printing start position.
Adjusting horizontal image position.
Adjust the off set value in vertical when
mapping data on a RAM.
Allows horizontal shifting of printing position
by specified number of dots per page.
Effective when load is applied to a specific
head area, like vertical lines.
Selecting media sensor.
Setting for small media.
Setting media length for small media.
Setting symbol set.
Displays level of sensor that is currently
selected.
Selects threshold of the sensor.
Sets the paper end level.
Setting for error report.