Citizen CL-S400DT User Manual page 13

Chapter 1 Setup
Part Names and Functions
Installing the Media (p.22)
Setting sensor positions (p.22)
Sensor Adjustments (p.45)
Inside the printer
1
2
-1
3
4
5
1 Thermal printhead
This is the printhead. Avoid touching this with your fingertips and
leaving grease or dirt on the printhead surface.
2 Media guides
(Left fixed media guide ( 2
The end of the media is matched to the left fixed media guide, then
the right side movable media guide is moved horizontally to match it
to the media size.
3 Front cover
It is removed to install optional units such as the peeler or cutter.
4 Platen
Interlocked with the thermal printhead, it feeds media backwards or
forwards.
5 Switch cover
It is opened when the cables of the cutter unit and the peeler unit are
connected. Do not remove during normal use.
6 Upper sensor ( 6
-1
When used as a transparent sensor (for labels and tags with notches),
it is used by matching the marker scale of the upper sensor and
the bottom sensor. When used as a reflective sensor, it is used by
matching the reflective sensor marker on the bottom sensor with the
position of the black mark on the liner or media backing.
7 Fixed sensor
In order to move the media to an appropriate place, black marks are
detected when they are set.
13
) and right movable media guide ( 2
-1
) and bottom sensor ( 6
6
-1
2
-1
6
-2
2
-2
7
))
-2
)
-2