Citizen CL-S400DT User Manual page 41

Chapter 2 Printer Operation
Mode Settings
[Zebra® Emulation]
Top Menu Sub Menu
Paper Position
Menu Key Action
Interfaces
RS-232C Baud
RS-232C Parity
RS-232C Length
RS-232C Stop bit
[RS-232C Stopbit]
RS-232C X-ON
IEEE1284
Web Monitor*
Network Address** 0.0.0.0
Subnet Mask**
Gateway Address** 0.0.0.0
BOOTP**
DHCP**
* Displayed when equipped with a SEH LAN board.
**Displayed when the Web Monitor is operating.
Default Menu
0.00 inch Peel/Cut/Tear Off
0.0 mm 0.00 to 2.00 inch
0.0 to 50.8 mm
Peel/Cut/Tear On
-1.00 to 1.00 inch
-25.4 to 25.4 mm
Enters Menu Enters Menu
Repeat Last One
9600 115200
57600
38400
19200
9600
4800
2400
None None
Odd
Even
8 bits 8 bits
7 bits
1 bit 1 bit
2 bits
Yes Yes
No
On On
Off
Auto Auto
On
Off
0.0.0.0 to
255.255.255.255
0.0.0.0 0.0.0.0 to
255.255.255.255
0.0.0.0 to
255.255.255.255
Off On
Off
Off On
Off
41
Remarks
Adjusts the stop position. It is based on the
inch/millimeter setting. There are initial
values of the stop position for each device
set above, and later, relative values are set.
Sets the menu key action.
Enters Menu:
Enters the menu setup mode.
Repeat Last One:
Last one is issued only for the final page.
In the case of a count, afterwards, only
last one is issued.
Note: Hold down the MENU key for at least
4 seconds in order to enter the Menu Setup
Mode when setting the "Repeat Last One"
menu.
Setting the baud rate of the serial interface.
• All settings related to the interface are
enabled after the power is reconnected.
Setting the communication parity for the
serial interface.
Setting the character length for the serial
interface.
Setting the stop bit for the serial interface.
Selectively setting the X-ON flow control of
the serial interface.
Setting both direction of the Centro
Interface.
Selecting the web monitor function.
Setting fixed IP address of the LAN board.
Setting fixed subnet mask value of the LAN
board.
Setting fixed default gateway address of the
LAN board.
Setting the BOOTP of the LAN board.
Setting the DHCP of the LAN board.