Citizen CL-S400DT User Manual page 24

Chapter 2 Printer Operation
Setting the Media
Media Sizes (p.21)
3. Set the media on the printer.
Firstly, slide the two black plastic parts of the media holder
assembly together. Ensure correct alignment of the guide
with the bar as it can only be installed in one direction.
4. Slide the roll of media over the media bar. The media guide
must be on the right side of the roll of media (as viewed from
the front of the printer) with the ribbed surface of the media
guide touching the media roll as shown in the illustration.
5. Set the media roll and media holder in to the printer as
shown above. It is advisable to pull a length of media
forwards and through the mechanism ready for later
positioning.
6. Move the media roll so it is touching the left side of the
housing. Then slide the black media guide so it is touching
the media on the right side. Do not try to hold the media too
tightly with these guides as it will cause the printer to jam
during printing.
24
Media holder guide
Media holder bar