Enabling Broadcom Netxtreme Gigabit Ethernet Boot Agent - IBM IntelliStation E Pro Type 6216 User Manual

Setting the password check jumper (JP1):
shows the location of the password check jumper (JP1) on the system board.
Rear fan
connector
AGP
PCI
connector 1
PCI
connector 2
Internal
speaker
PCI
connector 3
Complete the following steps to set the password check jumper (JP1):
1. Review the "Safety information" on page vii.
2. Turn off the computer and peripheral devices and disconnect all external cables
3. Move the jumper from pins 1 and 2 to pins 2 and 3. This clears the user password
4. Connect the computer to a power source, keyboard, monitor, and mouse.
5. Turn on the computer.
You can now start the Configuration/Setup Utility program and either delete the old
password or set a new user password.

Enabling Broadcom NetXtreme Gigabit Ethernet Boot Agent

The Broadcom NetXtreme Gigabit Ethernet Boot Agent is part of the BIOS code that
comes with your computer. You can enable the Broadcom NetXtreme Gigabit
Ethernet Boot Agent from the Configuration/Setup Utility program. The Broadcom
NetXtreme Gigabit Ethernet Boot Agent enables you to configure the network as a
startable device, and you can customize where the network startup option appears in
your startup sequence.
26
IBM IntelliStation E ProTypes 6216 and 6226:User's Guide
Microprocessor Microprocessor
and fan fan connector
(CN3)
and power cords; then, remove the cover. See "Turning off your computer" on
page 18 for instructions.
for one boot cycle.
Note: You can now start the computer one time without having to use the user
password, but if you do not use the Configuration/Setup Utility program to
change or delete the password, the next time you start the computer, the
original user password will be reinstated.
The following illustration
DIMM
DIMM
connector 1 connector 2
Boot block Battery
jumper (JP6)
System fan
connector 1
(CN2)
SCSI LED
connector
Password
check
jumper
(JP1)
CMOS
clear
jumper
(JP3)
®
Wake on LAN
connector