IBM IntelliStation E Pro Type 6216 User Manual page 74

Complete the following steps to install a DIMM:
Attention:
damage from static electricity. For details on handling these devices, see "Handling
static-sensitive devices" on page 31.
1. Review the safety precautions listed in the "Safety information" on page vii.
2. Turn off the computer and all attached devices. Disconnect all external cables
3. Touch the static-protective package containing the DIMM to any unpainted metal
4. Gently open the retaining clip on each end of the DIMM slot. Turn the DIMM so
5. Firmly press the DIMM straight down into the connector by applying pressure on
6. If there is a gap between the DIMM and the retaining clips, the DIMM has not
7. If you have other options to install or remove, do so now.
8. Replace the cover. See "Replacing the cover:" on page 46.
9. Reconnect the external cables and power cords. Turn on the attached devices,
Installing a security rope clip:
rope clip and cable to your computer.
Complete the following steps to install the rope clip:
1. Review the safety precautions listed in "Safety information" on page vii.
2. Turn off the computer and all attached devices. Disconnect all external cables
3. Use a screwdriver to remove the two metal knockouts.
4. Insert the rope clip through the rear panel; then, attach and tighten the nuts.
60
IBM IntelliStation E ProTypes 6216 and 6226:User's Guide
When handling static-sensitive devices, take precautions to avoid
and power cords; then remove the cover. See "Removing the cover:" on page 35
for details.
surface on the computer. Then, remove the new DIMM from the package.
that the pins align correctly with the connector.
both ends of the DIMM simultaneously. The retaining clips snap into the locked
position when the DIMM is firmly seated in the connector.
been correctly installed. Open the retaining clips, remove the DIMM, then reinsert
it.
and turn on the computer.
and power cords; then, remove the cover. See "Removing the cover:" on page 35
for details.
To help prevent theft, you can add a security
DIMM connector 1
DIMM connector 2