IBM IntelliStation E Pro Type 6216 User Manual page 58

12. Connect a power cable to the back of the drive. The connectors are keyed and can
13. If you have other options to install or remove, do so now.
14. Go to the appropriate section to work with another option, or replace the cover.
15. Reconnect the external cables and power cords; then, turn on the attached
Installing memory modules:
computer by installing memory modules. Your IntelliStation E Pro computer uses
industry standard, PC2100 266 MHz DDR dual inline memory modules (DIMMs).
Complete the following steps to install a DIMM.
Attention:
damage from static electricity. For details about handling these devices, see "Handling
static-sensitive devices" on page 31.
1. Review the safety precautions listed in the "Safety information" on page vii.
2. Turn off the computer and all attached devices. Disconnect all external cables
3. Lift the frame-support bracket. See "Removing the frame-support bracket:" on
4. Touch the static-protective package containing the DIMM to any unpainted metal
5. Gently open the retaining clip on each end of the DIMM slot. Turn the DIMM so
6. Firmly press the DIMM straight down into the connector by applying pressure on
7. If there is a gap between the DIMM and the retaining clips, the DIMM has not
8. If you have other options to install or remove, do so now.
44
IBM IntelliStation E ProTypes 6216 and 6226:User's Guide
Note: Make sure to route the signal cable so that it does not block the airflow to
the rear of the drives or over the microprocessor.
be inserted only one way.
See "Replacing the cover:" on page 46 for details.
devices and the computer.
When handling static-sensitive devices, take precautions to avoid
and power cords; then, remove the cover. See "Removing the cover:" on page 35
or for details.
page 35.
surface on the computer. Then, remove the new DIMM from the package.
that the pins align correctly with the connector.
both ends of the DIMM simultaneously. The retaining clips snap into the locked
position when the DIMM is firmly seated in the connector.
been correctly installed. Open the retaining clips, remove the DIMM, and then
reinsert it.
You can increase the amount of memory in your
DIMM connector 1
DIMM connector 2