Chapter 2 Front-Panel Overview
To Configure the Remote Interface
To Configure the Remote Interface
The instrument is shipped with both an HP-IB ( IEEE -488) interface
and an RS -232 interface. Only one interface can be enabled at a time.
The HP-IB interface is selected when the instrument is shipped from
the factory.
HP-IB Configuration
1 Select the HP-IB interface.
Interface
+3,%
2 Select the HP-IB address.
Interface
You can set the instrument's address to any value between 0 and 30.
The factory setting is address "9".
$''5(66
3 Save the change and exit the menu.
Interface
Note: Your computer's HP-IB interface card has its own address.
Be sure to avoid using the computer's address for any instrument on the
interface bus. Hewlett-Packard HP-IB interface cards generally use
address "21".
46