Table of Contents
Advertisement
Chapter 4 Features and Functions
Remote Interface Configuration
Baud Rate Selection (RS-232)
You can select one of eight baud rates for RS -232 operation. The rate is
set to 57,600 baud when the instrument is shipped from the factory.
You can set the baud rate from the front panel only.
Select one of the following: 1200, 2400, 4800, 9600, 19200, 38400,
(factory setting), or 115200 baud.
57600
The baud rate selection is stored in non-volatile memory, and does not
change when power has been off, after a Factory Reset (*RST
command), or after an Instrument Preset (SYSTem:PRESet command).
Front-Panel Operation:
19200 BAUD
Parity Selection (RS-232)
You can select the parity for RS -232 operation. The instrument is
configured for no parity with 8 data bits when shipped from the factory.
You can set the parity from the front panel only.
Select one of the following: None (8 data bits), Even (7 data bits),
or Odd (7 data bits). When you set the parity, you are also indirectly
setting the number of data bits.
The parity selection is stored in non-volatile memory, and does not
change when power has been off, after a Factory Reset (*RST
command), or after an Instrument Preset (SYSTem:PRESet command).
Front-Panel Operation:
EVEN, 7 BITS
152
Advertisement
Table of Contents
