HP 34970A User Manual page 211

Chapter 5 Remote Interface Reference
The MEASure? and CONFigure Commands
CONFigure:FREQuency
CONFigure:PERiod
[{< range >|AUTO|MIN|MAX|DEF}
resolution scan_list
[,< >|MIN|MAX|DEF}],] ( @ < >)
Configure the specified channels for frequency or period measurements
but do not initiate the scan. Note that this command also redefines the
scan list.
scan_list
CONFigure:DIGital:BYTE ( @ < >)
Configure the instrument to read the specified digital input channels
on the multifunction module but do not initiate the scan. Note that this
command also redefines the scan list. The digital input channels are
numbered "s01" ( LSB ) and "s02" ( MSB ), where s is the slot number.
Note that if you include both digital input channels in the scan list,
the instrument will read data from both ports simultaneously with the
same time stamp. This will allow you to externally combine the two
8-bit value into one 16-bit value.
CONFigure:TOTalize {READ|RRESet} ,( @ < scan_list >)
5
Configure the instrument to read the specified totalizer channels on the
multifunction module but do not initiate the scan. Note that this command
also redefines the scan list. The totalizer channel is numbered "s03",
where s represents the slot number.
To read the totalizer during the scan without resetting the count, select
the READ parameter. To read the totalizer during the scan and reset the
count to "0" after it is read, select the RRESet parameter (this means
"read and reset").
@ ch_list
CONFigure? [( < >)]
Query the present configuration on the specified channels and return a
series of quoted strings. If you omit the optional ch_list parameter,
the instrument uses the active scan list. The command returns a series
of comma-separated fields as shown in the example below. Each field
contains the function, range, and resolution.
"FRES +1.000000E+02,+3.000000E-04" , "TEMP TC,K,+1.000000E+00,+3.000000E-06"
213