HP 34970A User Manual page 47

Data acquisition / switch unit
Table of Contents

Advertisement

Chapter 2 Front-Panel Overview
To Configure the Remote Interface
RS-232 Configuration
1 Select the RS-232 interface.
Interface
2 Select the baud rate.
Interface
Select one of the following: 1200, 2400, 4800, 9600, 19200, 38400,
57600 (factory setting), or 115200 baud.
3 Select the parity and number of data bits.
Interface
Select one of the following: None (8 data bits, factory setting),
Even (7 data bits), or Odd (7 data bits). When you set the parity,
you are also indirectly setting the number of data bits.
4 Select the flow control method.
Interface
Select one of the following: None (no flow control), RTS/CTS , DTR/DSR ,
XON/XOFF
5 Save the changes and exit the menu.
Interface
,
(factory setting), or Modem.
2
47

Advertisement

Table of Contents
loading

Table of Contents