Switching On The Monitor And Device - Fujitsu PRIMERGY MX130 S1 Operating Manual

Preparing for use
– The indicator is not lit up:
the device is switched off or is ready for operation. If your device is ready for operation, it
can be switched on with the ON/OFF switch.
3 - Hard disk indicator
The indicator lights up when the hard disk of the device is accessed.

Switching on the monitor and device

► Switch on the monitor (refer to the operating manual for the monitor).
► Switch the device on. To do this, follow the instructions below.
Depending on the version, the device may be equipped with a main power switch on the
i
back of the device in addition to the ON/OFF button on the front. As a result, there are
different ways to switch on the two variants.
Consequently, the illustrations shown below may differ slightly from your actual model.
Switching on the device (with the main power switch)
0 = device is switched off
► Switch on the device via the main power switch (1) on the back of the device.
22
1
I = device is ready
Fujitsu Technology Solutions
I
0