Installing And Removing An Additional Optional Port; Installing An Optional Port - Fujitsu PRIMERGY MX130 S1 Operating Manual

Installing and removing an additional optional port

An additional port can be installed in a rear slot cover plate like a board. For an exact description of
how to connect external devices to ports, refer to the documentation for the device.

Installing an optional port

► Open the casing (see "Opening the casing").
► Press on the locking lever in the direction of the arrow (1), unhook it and swing it up in the
direction of the arrow (2).
► Remove the rear slot cover plate from the slot (3).
Do not dispose of the rear slot cover plate of the slot. For cooling, protection against fire
!
and in order to comply with EMC regulations (regulations regarding electromagnetic
compatibility), you must refit the rear slot cover plate if you later remove the port.
► Push the port into the slot (4) as far as it will go.
► Press the port into the slot until you feel it engage.
► Fold the lock closed in the direction of the arrow (5) and allow it to engage.
► Connect the cable of the additional port to the connector on the mainboard.
► Close the casing (see "Closing the casing").
Fujitsu Technology Solutions
2
1
3
System expansions
5
4
47