Completing The Installation - IBM eServer BladeCenter JS20 Type 8842 Installation And User Manual

17. Reset the system date and time through the operating system that you

Completing the installation

To complete the installation, perform the following tasks, if you have not already
done so.
1. Install the blade-server bezel assembly on the blade server (see "Installing the
2. Close the blade server cover (see "Closing the blade server cover" on page 50).
3. Reinstall the blade server into the BladeCenter unit (see Chapter 3, "Installing
4. Turn on the blade server (see "Turning on the blade server" on page 51).
5. After you replace the battery or the system-board assembly, reset the system
Note: If you have just connected the power cords of the BladeCenter unit to
48
BladeCenter JS20 Type 8842: Installation and User's Guide
The blade server will not start until the serial number and other relevant
information have been entered and verified at the prompts when the following
checkpoint codes are displayed, as shown in the following example window.
Depending on the blade server configuration, the text that is displayed in your
system window might be slightly different.
E1F0
E1F1
D099
D100 > xxxxxxx (The serial number of the blade server with the original
system-board assembly)
D101 > xxxxxxx (Re-enter the serial number to verify)
D102 > 8842 (The type number from the blade server)
D103 > 8842 (Re-enter the type number to verify)
D104 > xxxx (The model number from the blade server)
D105 > xxxx (Re-enter the model number to verify)
Note: These checkpoint codes are described in Chapter 10, "Solving
problems," on page 57.
installed. For additional information, see your operating-system documentation.
The system-board assembly replacement procedure is now complete. Continue
with "Input/output connectors and devices" on page 50.
blade-server bezel assembly" on page 49).
Statement 21:
CAUTION:
Hazardous energy is present when the blade server is connected to the
power source. Always replace the blade cover before installing the blade
server.
the blade server in the BladeCenter unit," on page 9).
date and time through the operating system that you installed. For additional
information, see your operating-system documentation.
electrical outlets, you will have to wait until the power-on LED on the blade
server flashes slowly before pressing the power-control button on a blade
server.