IBM eServer BladeCenter JS20 Type 8842 Installation And User Manual page 87

Checkpoint code Description
E210 Load and relocate the hardware
isolation layer (HIL).
E211 CRC check of the image in flash
RAM.
E212 Get processor status and presence.
E213 Memory initialization.
E214 Pattern 1 memory test.
E215 Pattern 2 memory test.
E216 Clear memory.
Suggested action
1. Perform the system checkout procedure. See
"System checkout" on page 58.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
1. Perform the system checkout procedure. See
"System checkout" on page 58.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
1. Perform the system checkout procedure. See
"System checkout" on page 58.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
1. Make sure that the DIMMs are correctly installed
and seated; then, restart the blade server.
2. Start the blade server from the PERM flash image
to recover the TEMP image. See "Recovering the
system firmware code" on page 95.
3. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
1. Make sure that the DIMMs are correctly installed
and seated; then, restart the blade server.
2. Start the blade server from the PERM flash image
to recover the TEMP image. See "Recovering the
system firmware code" on page 95.
3. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
1. Make sure that the DIMMs are correctly installed
and seated; then, restart the blade server.
2. Start the blade server from the PERM flash image
to recover the TEMP image. See "Recovering the
system firmware code" on page 95.
3. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
1. Make sure that the DIMMs are correctly installed
and seated; then, restart the blade server.
2. Start the blade server from the PERM flash image
to recover the TEMP image. See "Recovering the
system firmware code" on page 95.
3. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
Chapter 10. Solving problems
71