IBM eServer BladeCenter JS20 Type 8842 Installation And User Manual page 60

10. Close the blade server cover (see "Closing the blade server cover" on page
11. Reinstall the blade server into the BladeCenter unit (see Chapter 3, "Installing
12. Turn on the blade server (see "Turning on the blade server" on page 51).
13. Reset the system date and time through the operating system that you
44
BladeCenter JS20 Type 8842: Installation and User's Guide
8. Remove the battery:
a. Use your finger to press down on one side of the battery; then, slide the
battery out from its socket. The spring mechanism will push the battery out
toward you as you slide it from the socket.
Note: You might need to lift the battery clip slightly with your fingernail to
make it easier to slide the battery.
b. Use your thumb and index finger to pull the battery from under the battery
clip.
Note: After you remove the battery, press gently on the clip to make sure
that the battery clip is touching the base of the battery socket.
9. Insert the new battery:
a. Tilt the battery so that you can insert it into the socket, under the battery
clip. Make sure that the side with the positive (+) symbol is facing up.
b. As you slide it under the battery clip, press the battery down into the
socket.
50).
Statement 21:
CAUTION:
Hazardous energy is present when the blade server is connected to the
power source. Always replace the blade cover before installing the blade
server.
the blade server in the BladeCenter unit," on page 9).
installed. For additional information, see your operating-system documentation.