Printronix T3204 series Operator's Manual page 15

Printers have been built with two types of
standard media hubs: metal and plastic.
From the diagrams below , follow the media
loading instructions which match your
printer.
Do not use the media retainer if the media
supply roll is wider than 4 inches.
METAL HUB
a If you are using media
with a 3" core, place the
3" media core adapters
on the media hub
assembly.
b Place the media supply
roll on the media hub
assembly. Slide the media
retainer against the
supply roll and tighten the
thumb screw.
PLASTIC HUB
a Place the 3" media
supply roll on the media
hub assembly.
b Slide the media
retainer against the
supply roll and tighten the
thumb screw.
c Skip the next step and continue with
step 7.
Operator' s Guide
note
note
loading media
7